Home › Tools › Tracks and roads
Track and road take-off online
Paste the longitudinal profile (or import the DXF), describe the typical cross-section: carriageway, shoulders, slopes, ditches and layers. The tool computes every cross-section, the cut and fill volumes, topsoil stripping, pavement layers, ditches, the mass haul curve and the bill of quantities.
Take-off
From the longitudinal profile to volumes
For each profile, the formation level is placed below the design level, at the thickness of the pavement layers. The typical cross-section is set on it: platform (carriageway and shoulders), then cut or fill slopes until they meet the existing ground, with a ditch on each side in cut. The cut and fill areas of the cross-section are computed, then the volume between two profiles by the average end area method, the one used in road specifications.
The existing ground is assumed horizontal across the section, unless you give its cross slope (in %, positive towards the right): useful on a hillside, where a section is often in cut on one side and in fill on the other.
Paved road or track
- Road: capping layer, sub-base, base course, prime coat, then double or single surface dressing or asphalt concrete (in tonnes).
- Track: a wearing course of selected material (crusher-run), with no surfacing.
Reading the mass haul curve
The curve accumulates cut − fill along the alignment. When it rises, the road is in cut; when it falls, in fill. Between a trough and a crest, the cut can be used for the neighbouring fill: this is the basis of a good earthwork balance and haul distance study.
Frequently asked questions
How do I calculate the earthwork volume of a road?
Compute the cut and fill area of each cross-section, then the volume between two sections = (area 1 + area 2) / 2 × distance. The tool does it for all the profiles and adds them up.
Which slope should I use?
Often 1/1 in cut (1 horizontal to 1 vertical) in ordinary soil, 1/2 to 1/3 in rock, and 3/2 (1.5 horizontal to 1 vertical) in fill. Your geotechnical study gives the value to use.
Can I import a longitudinal profile from Covadis?
Yes: save the longitudinal profile as DXF and import it; the tool reads the rows of existing ground levels, design levels and distances. You can also paste the table from Excel: profile, chainage, ground level, design level.
Is the crossfall taken into account?
The carriageway crossfall (generally 2.5%) changes the volumes very little; it is not taken into account in the earthworks. The layers are computed with their constant thickness.
How is topsoil stripping measured?
Over the whole footprint of the section (platform, ditches and slopes) multiplied by the topsoil thickness, between two profiles.